It has waterproofing, adhesion and extreme flexibility, sealing cracks and solving difficult-to-solve chronic leak and infiltration problems. It is completely hydrophobic and its cured film makes it completely water-repellent.
• Single-component product;
• Elasticity above 450%;
• Forms a resistant film on the substrate;
• Stable against UV rays;
• Water resistant;
• White product;
• Easy to apply;
• Changes the appearance of the surface where it is applied, reviving the natural color with a little shine;
• Has chemical resistance similar to natural rubber;
• Offers good protection of the substrate against chemical attacks in general: acids and bases;
• Capable of withstanding hailstorms due to its extremely flexible film, considerably reducing the impact of objects, also reducing noise; 5-year product warranty, except for design flaws, structural flaws or misuse of the material, as long as the application method below is followed.
The average yield of the product is 5 to 12 m²/L per coat, depending on the roughness of the applied surface. The more porous/rough, the lower the yield.
4 coats: Water tanks
2 coats: Other locations
In places with temperatures above 25ºC, the curing time between coats is up to one hour.
In places with temperatures below 25ºC, the curing time between coats is up to two hours.
Use a personal protective mask (ABEK or ABEK-P2 gas filter are mandatory), nitrile or butyl rubber gloves, safety glasses or face protection, waterproof protective clothing (gloves and aprons) and protective boots. If you experience any symptoms of allergy, skin irritation or contact with your eyes, seek medical attention immediately.
Do not reuse the packaging for food purposes, and do not smoke while handling the product. Care should be taken with open packaging in the presence of children, whether or not there is product inside. Do not allow the product to reach water, sewage or soil.
Product certified by HBC (Healthy Building Certificate), as a product that does not pose any risk to human health or the environment, and is therefore a healthy and sustainable product. HBC grants the MOSHE 3000 product the title of Qualified and Certified Product registered under Code PROD20201007BRAPR0050, valid until August 23, 2026.
According to the FALCAO BAUER Report TEST REPORT No. MAT/388.274/1/Preliminary/24, in accordance with ABNT NBR 13321:2023 standard - Acrylic membrane for waterproofing, class "C", it was found that in the Tensile strength test at rupture tension, it reached 17.6 MPa, where the recommended minimum is 1.5 MPa and in the Elongation at rupture test, it reached 450% where the recommended minimum is 100%. In the Elongation at rupture test after accelerated aging in ultraviolet for 1000 hours, with cycles of 4 hours of ultraviolet at 60°C and 4 hours of condensation at 50°C, it reached XXX% where the recommended minimum is 100%. It was found that in the Water Absorption test 0.07% where the maximum allowed by the standard is 15%.
According to the FALCÃO BAUER TEST REPORT No. MOV/388.274/1/25, in accordance with ABNT NBR 17088:2023 – Corrosion by Exposure to Salt Mist – Test Methods, it was found that after 1000 hours of testing with neutral salt mist with running water at a temperature below 40ºC there was no presence of corrosion.
According to the PROJECT REPORT – NSF/ANSI 61 SAFETY TEST No. RL 21218/2024, it was found that in the Safety Test of the single-component liquid waterproofing material Moshe 3000 New Flex, it complies with the NSF/ANSI 61 - 2016 standard, Drinking Water System Components - Health Effects (NSF International Standard / American National Standards Institute) and based on the OECD – Principles on Good Laboratory Practice (1997).
Our team is ready to answer all your questions about Moshe 3000.
Get in touch
